PT Journal
AU Dobes, J
   Kozubkova, M
TI The Numerical Solution of the Aerodynamic Task Using by CFD Modelling
SO Manufacturing Technology Journal
PY 2015
BP 788
EP 795
VL 15
IS 5
DI 10.21062/ujep/x.2015/a/1213-2489/MT/15/5/788
DE aerodynamic; numerical modeling; CFD code; simple body; hot-wire anemometer
AB The solution of the aerodynamic task is a very complex issue. An accurate description of the aerodynamic field is used for the specification and the solution of an aero-acoustic task. With the numerical modelling onset the possibilities of investigation of the flow around body are still expanding. The aim is to establish basic parameters by which the flow field around the body is described. This paper deals with the numerical modelling of the flow around a cylinder and a sphere and with the evaluation of the parameters (coefficients) for these bodies. The modelling is performed using the software tools Ansys Fluent and OpenFOAM. The basic setting of the numerical simulation is described and test of the calculation stability and mesh quality for a given task is done. The calculation setup is briefly shown for the computational tool OpenFOAM. At the same time, the experimental result is shown in this paper to verify the results of the numerical simulations. The experimental equipment - a wind tunnel is specified by its basic parameters and possibilities for the aerodynamic task measuring. Experimental data are obtained using by hot-wire anemometry - one-wire and two-wire probe.
ER