RT Journal Article
SR Electronic
A1 Jirouš, Stanislav
A1 Fraňa, Karel
T1 Pressure Analysis on the Surface Gearing Investigated by Numerical Simulation of Oil Flow in the Tooth Wheel Gap
JF Manufacturing Technology Journal
YR 2015
VO 15
IS 5
SP 850
OP 853
DO 10.21062/ujep/x.2015/a/1213-2489/MT/15/5/850
UL https://journalmt.com/artkey/mft-201505-0019.php
AB The key topic of this article is a study of the oil flow and pressure distribution on the surface gearing investigated using numerical simulations. Particularly, this paper is focused on a simulation of the single flow of oil, which is governed by the gearing motion. Results of the unsteady flow between two rotating gearing could help to identify reasons of damages of gearings. The destruction of surface is identified after several hours on the helical gearing which is used in a heavy industry. In the case of moving and rotating gearing, it was necessary to use dynamic mesh and procedure of remeshing based on the parameters of quality cells. The simulation provides the complete information of pressure distribution on the surface of gearings. By the analysis of numerical results the areas with the high frequencies of low pressure were identified.