PT Journal
AU Pitrmuc, Z
   Capek, J
   Kolarik, K
   Beranek, L
   Urban, J
TI Tool Geometry Influence on Surface Integrity of Machined Austenite Stainless Steel
SO Manufacturing Technology Journal
PY 2016
BP 425
EP 431
VL 16
IS 2
DI 10.21062/ujep/x.2016/a/1213-2489/MT/16/2/425
DE Austenite Stainless Steel; Strain-induced Martensite; Tool Geometry; Residual Stresses; Roughness
AB The goal of this contribution was to describe the microstructure and properties changes of difficult to cut materials after turning. Surface residual stresses, roughness, microstructure of AISI 304 type stainless steel were studied as a function of side rake angle o. Residual stresses and phase composition of surface and sub-surface layers were determined using X-ray diffraction techniques. The presence of strain-induced martensite was investigated using Barkhausen noise, optical microscope, and microhardness measurement.
ER