RT Journal Article
SR Electronic
A1 Svobodová, Jaroslava
A1 Luňák, Milan
A1 Lukáč, Ivan
T1 Identification of the "Snowflakes" on the Machined Surface of the AlSi10Mg Alloy Casting
JF Manufacturing Technology Journal
YR 2019
VO 19
IS 5
SP 868
OP 873
DO 10.21062/ujep/386.2019/a/1213-2489/MT/19/5/868
UL https://journalmt.com/artkey/mft-201905-0025.php
AB The usage of aluminium alloys has an increasing trend in the manufacturing industry in recent years. This fact is connected with their ability to combine their very good properties. Characteristics of aluminium are low specific weight, very good thermal and electrical conductivity, and ductility. However, the major disadvantages are low strength and hardness. Therefore the aluminium alloys are alloyed with the elements, which would significantly improve the properties of aluminium. The machining process of aluminium alloys is influenced by many factors that affect the machinability. These factors are for example process conditions, cutting tool material, cutting tool geometry, cutting environment or the chemical composition of the machined material itself and microstructure of the workpiece. Due to the different structures, the machinability of aluminium alloys and pure aluminium is significantly different. Factors such as chemical composition, precipitates, the number and position of soft particles or the strain hardening degree affect the behaviour between the cutting tool and the workpiece during machining. When machining the aluminium alloys, there are some problems such as the surface quality, micro-geometry, tool wear, the chip shape, built-up edge formation, etc. The article deals with the surface defect investigation after the machining process, when on the surface of the material stay the visible "snowflakes" after the turning operation. These "snowflakes" were documented and were performed analysis and observation to find the cause of these flakes.