PT  - JOURNAL ARTICLE
AU  - Stancekova, Dana
AU  - Mrázik, Jozef
AU  - Görögová, Ingrid
AU  - Miturska, Izabela
AU  - Ščotka, Peter
AU  - Turian, Filip
TI  - Milling of Technical Ceramics ROCAR SiSiC
DP  - 2020 Aug 18
TA  - Manufacturing Technology Journal
PG  - 250--256
VI  - 20
IP  - 2
AID - 10.21062/mft.2020.025
IS  - 12132489
AB  - The paper deals with hard machining of ceramic construction materials that are still more applied in the automo-bile industry as well as other branches due to their specific properties, such as hardness, corrosion resistance, heat resistance, etc. Concretely, we speak of milling of technical ceramics ROCAR SiSiC. Our intention is the right se-lection of suitable tool materials, tool geometry as well as a definition of optimum cutting parameters by the min-imum cost. After the selection of optimum technology, identified cutting plates were compared and experimentally verified in the process. Results of verifications the right choice of selected cutting plate is a comparison of compo-nents of cutting force originating in the process of machining and also the quality of machined surfaces after mill-ing of hard and brittle material.