RT Journal Article
SR Electronic
A1 Hrbackova, Lucie
A1 Sedlak, Josef
A1 Chromjakova, Felicita
A1 Macurova, Lucie
A1 Jurickova, Eva
A1 Dobrocky, David
A1 Skerik, Filip
T1 Evaluation of the Effect of Machining Technologies on the Surface Texture Analysis of Ertacetal C Polymer
JF Manufacturing Technology Journal
YR 2023
VO 22
IS 6
SP 679
OP 692
DO 10.21062/mft.2022.083
UL https://journalmt.com/artkey/mft-202206-0008.php
AB The surface created by machining significantly affects the service life and functional reliability of the component. As part of this study, four different chip machining technologies were evaluated on the surface texture of the polymer material Ertacetal C. The samples were processed by turning, milling, grinding and polishing technologies, 5 samples for each technology. Within the given technology, different cutting conditions were chosen to compare the effect of cutting conditions on the resulting surface roughness. The machined surfaces were comprehensively evaluated on the basis of 16 profile and surface roughness parameters due to the practical use of the tested material. Surface texture measurements were performed on a Talysurf CCI Lite device. A non-contact method using a coher-ence correlation interferometer was used for the measurement. The obtained data were evaluated using TalyMap Platinum software. Graphical documentation of the machined surfaces was made using an Olympus DSX500 opto-digital metallographic microscope.