PT Journal
AU Naprstkova, N
   Sramhauser, K
   Hren, I
   Novotny, J
   Sviantek, J
TI Microscopic Wear Analysis of Indexable Inserts after Machining of 34CrNiMo6 Steel
SO Manufacturing Technology Journal
PY 2023
BP 676
EP 684
VL 23
IS 5
DI 10.21062/mft.2023.077
DE Turning; Cutting Insert; Tool Wear; Steel; Electron Microscopy
AB Machining is an important part of the manufacturing process in the engineering field. Turning is one of these areas. At present, almost exclusively exchangeable cutting inserts are used in production machining. The article describes the research in the field of their wear, where the electron microscopy was used to evaluate the results. Electron microscopy is a very important aid in research in many are-as not only of human activity and also is the important aid in the field of mechanical engineering and manufacturing technologies. The results thus obtained can make in a given area it clearer and better document the resulting situation. Within the experiments, selected cutting inserts were used and the given material was machined. The electron microscope Tescan Vega 3, which is available at the workplace where the experiment was conducted, was used to evaluate the resulting wear. In the frame of experiments was also performed the composition analyze of used cutting inserts. Analyzes of the machined material were also performed to confirm the declarations from the supplier.
ER