RT Journal Article
SR Electronic
A1 Majerík, Jozef
A1 Majerský, Juraj
A1 Chochlíková, Henrieta
A1 Barényi, Igor
A1 Escherová, Jana
A1 Kubasáková, Mária
T1 Machining of M390 Microclean® and M398 Mircoclean® PM Steels - the Comparison of Cutting Forces and Surface Roughness
JF Manufacturing Technology Journal
YR 2023
VO 23
IS 6
SP 853
OP 860
DO 10.21062/mft.2023.096
UL https://journalmt.com/artkey/mft-202306-0014.php
AB Article deals with comparison of cutting forces and surface roughness between materials produced by powder metallurgy M390 and M398 Microclean® from producer, company Böhler. Main interest is the analysis & comparison of the cutting forces and surface roughness after the processing by cutting in-serts with DNMG and WNMG geometry, radius 0.4 and 0.8 mm, after hard turning at the same pro-cess parameters for both materials and all types of cutting inserts. The comparative studies were car-ried out for cutting forces and surface roughness with the aiming to observe the difference between "old generation" M390 and "new generation" M398 PM Steel for future processing in production. The corelation between the cutting forces and surface roughness was investigated with resulting the M398 is necessary to process by higher cutting forces which are linked with higher surface roughness than at M390. It is in relation with higher contain of additive elements and carbides formed by them, even that the material is in delivered condition - soft annealed [1], [2]. These results helped to fulfil the knowledge about both materials in the row of experiments which are provided to increase material properties against abrasion and wear.