PT  - JOURNAL ARTICLE
AU  - Waszczuk, Kamil Piotr
TI  - Influence of Technological Parameters on the Cutting Temperature during Trochoidal Milling
DP  - 2024 Feb 23
TA  - Manufacturing Technology Journal
PG  - 148--153
VI  - 24
IP  - 1
AID - 10.21062/mft.2024.001
IS  - 12132489
AB  - The aim of the article was to present the results of cutting temperature measurements during trochoidal milling. The investigated material was 145Cr6 (50 HRC). Three trochoidal paths were used: A- described by movement circle, B- described by arcs and straight lines, C- described by short lines between a lot of points. The main conclusions include: similar values of cutting tem-peratures when using paths A and C (differences between the values of about 5%), the use of a trochoidal path type B enables a significant reduction of the cutting temperature. During tro-choidal milling, the maximum temperature values were about 420ºC.