Manufacturing Technology 2020, 20(6):720-727 | DOI: 10.21062/mft.2020.088

Microstructure of zirconium fuel claddings: TEM and EBSD studies of as-received and ne-utron-irradiated materials

Petra Gávelová1, Patricie Halodová1, Barbora Křivská1, Cinthia Antunes Correa1, Jakub Krejčí2, Martin Ševeček3, Vít Rosnecký1
1 Research Centre Řež, s.r.o., Department of Material and Mechanical Properties, Hlavní 130, 250 68, Husinec-Řež, Czech Republic
2 UJP Praha a.s., Department of Alloys and Pseudoalloys, Nad Kamínkou 1345, 156 10 Prague, Czech Republic
3 ALVEL, Opletalova 37, 110 00 Prague, Czech Republic

Zirconium fuel claddings act as a first barrier against release of fission products during nuclear power plant operation and interim storage of the spent fuel. During the reactor operation, cladding tubes are exposed to different stress level at elevated temperatures and neutron irradiation in corrosive environment. It causes a material degradation by corrosion, cladding embrittlement by hydrides and radiation-induced damage or radi-ation growth and creep of the fuel rods. The irradiation damage effects mainly contribute to the loss of material ductility. In our study, microstructure of as-received (non-irradiated) Zr-alloys used in LWR (Zr1Nb, Zr-1Nb-1.2Sn-0.1Fe, Zr-1.5Sn-0.2Fe-0.1Cr) were examined by electron microscopy methods. Transmission electron microscope (TEM) was used to describe the microstructure of claddings used in different reactor conditions and identify the radiation-induced damage, which is presented on Zr1Nb irradiated to one standard campaign in the VVER-1000 active zone. Following Electron Backscatter Diffraction (EBSD) method on transparent foils complements the TEM results in larger area, i. e. by grain size and orientation or analysis of local misorienta-tion after irradiation. Radiation-induced damage was observed in Zr1Nb metallic matrix as type disloca-tion loops, presence of radiation-induced precipitates or partial amorphization of the secondary phase particles. EBSD method showed no changes in crystallographic orientation, but a local increase of dislocation density can be affected by neutron irradiation.

Keywords: Zirconium alloys, Light Water Reactors, Neutron irradiation, TEM, EBSD
Grants and funding:

The Ministry of Education, Youth and Sport Czech Republic - project LQ1603 Research for SUSEN. The SUSEN Project (established in the framework of the European Regional Development Fund (ERDF) in project CZ.1.05/2.1.00/03.0108 and of the European Structural and Investment Funds (ESIF) in the project CZ.02.1.01/0.0/0.0/15_008/0000293) and Innovations for Competitiveness, Application - Call IV., CZ.01.1.02/0.0/0.0/17_107/0012555, 2017-2020.

Received: August 30, 2020; Revised: October 11, 2020; Accepted: October 12, 2020; Prepublished online: December 11, 2020; Published: December 23, 2020  Show citation

ACS AIP APA ASA Harvard Chicago IEEE ISO690 MLA NLM Turabian Vancouver
Gávelová P, Halodová P, Křivská B, Antunes Correa C, Krejčí J, Ševeček M, Rosnecký V. Microstructure of zirconium fuel claddings: TEM and EBSD studies of as-received and ne-utron-irradiated materials. Manufacturing Technology. 2020;20(6):720-727. doi: 10.21062/mft.2020.088.
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. CENGEL Y. A., C. J. (2006). Fluid Mechanics: Fundamental and Applications, pp. 817-842. New York, USA
    2. NAMBURI, H., OTTAZZI, L., CHOCHOLOUSEK, M., KREJCI, J. Study of hydrogen embrittlement and determination of E110 fuel cladding mechanical properties by ring compression testing, 2018. In Interna-tional Conference on materials and Metallurgy. 2018. ISBN: 978-80-87294-84-0. Go to original source...
    3. WEIDINGER, H. G.: Zr-Alloys, the Nuclear Material for Water Reactor Fuel, In 7th International Conference on WWER Fuel Performance, Albena, Bulgaria, 2007.
    4. IAEA: Delayed hydride cracking in zirconium alloys in pressure tube nuclear reactors. In Final report of a co-ordinated research project 1998-2002. IAEA-TECDOC-1410. Oct 2004.
    5. BLAT-YRIEIX, M., BOUFFIOUX, P. ET AL.: Hydrogen pick-up in Zr-alloys. Phenomenology and im-pact on fuel assembly component behaviour. Lecture in Metallurgy and properties of Zr alloys for nuclear applications. Saclay. 2017.
    6. CHOI S.I., KIM E.H.: Radiation-Induced Dislocation and Growth Behavior of Zirconium and Zirconium Alloys - A Review. In Nuclear Engineering and Technology, 45 (3), 385-392, 2013. Go to original source...
    7. V. N. Shishov, A. V. Nikulina, V. A. Markelov, M. M., Peregud, A. V. Kozlov, A. V. Averin, S. F. Kolben-kov, A. E. Novoselov. Influence of neutron irradiation on dislocation structure and phase compositin of Zr-base alloys. In Zirconium in the Nuclear Industry: 11th Int. Symp., Garmisch-Partenkirchen, Germany, Sept. 11-14, 1995, ASTM STP 1295, p. 603, 1996.
    8. Liu, J., He, G., Callow, A., Li, K., Lozano-Perez, S., Wilkinson, A., Moody, M., Grovenor, Ch., Hu, J., Kirk, M., Li, M., Haq Mir, A., Hinks, J., Donelly, S., Partezana, J., Nordin, H.: Ex-situ and In-situ Studies of Ra-diation Damage Mechanisms in Zr-Nb Alloys. In ASTM 19th Symposium on Zirconium in the Nuclear Industry.
    9. Griffiths, M.; Gilbert, R. W.; Carpenter, G. J. C. J. In Nucl. Mater. 1987, 150(1), 53-66. Go to original source...
    10. HOJNÁ, A. Overview of Intergranular Fracture of Neutron Irradiated Austenitic Stainless Steels. Metals [online]. 2017, [cited 2020-08-17]. Available from: http://www.mdpi.com/journal/metals/special_issues/radiation_effects. ISSN 2075-4701. Go to original source...
    11. BUBLÍKOVÁ, P., HALODOVÁ, P., FOKT, M., NAMBURI, H., ROSNECKÝ, V., PROCHÁZKA, J., DUCHOŇ, J., VOJTĚCH, D.: Neutron irradiated reactor internals: An applied methodology for specimen preparation and post irradiation examination by electron microscopy methods. Manufacturing technology 2018. 18 (4), p. 545 - 551. Go to original source...
    12. VACKOVÁ, M., VALKO, M., PAVLENKO, S., HALKO, J.: Methodology of increasing safety of welding joints in pressure vessels X5CrNi18-10. Manufacturing Technology 2017. 17 (4). p. 611-617. Go to original source...
    13. KREJČÍ, J. Oxidace palivového pokrytí v tepelně-chemických podmínkách jaderného reaktoru. Disertační prá-ce. České Vysoké Učení Technické v Praze. Fakulta Jaderná a Fyzikálně Inženýrská. Praha, 2018.
    14. BANERJEE, S.: Nuclear Applocations: Zirconium Alloys, Encyclopedia of Materials: Science and Tech-nology (Second Edition) 2001, Pages 6287-6299, https://doi.org/10.1016/B0-08-043152-6/01117-7. Go to original source...

    This is an open access article distributed under the terms of the Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content