Manufacturing Technology 2021, 21(4):544-558 | DOI: 10.21062/mft.2021.065

Power Injection Method-based evaluation of the effect of binding technique on the Coupling Loss Factors and Damping Loss Factors in Statistical Energy Anal-ysis simulations

Marcell Ferenc Treszkai ORCID...1, Alexander Peiffer ORCID...2, Daniel Feszty ORCID...1
1 Audi Hungaria Faculty of Automotive Engineering, Department of Whole Vehicle Engineering, Széchenyi István University. Egyetem tér 1, H-9026 Gyõr. Hungary
2 Audi AG, I/XX-99, 85045 Ingolstadt, Germany

Measurement results on the Damping Loss Factor (DLF) and Coupling Loss Factor (CLF) between two steel plates is presented for 19 different junction types. The junctions involve joining technologies as line welding, point welding, bolting, riveting, gluing or their combinations, with parameters, such as spac-ing between the junction points or the angle between the plates varying. From the measurement results the DLF and CLF values were calculated by the Power Injection Method for the purposes of being ap-plied in Statistical Energy Analysis simulations. Four excitations were applied at each subsystem by impact hammer, while the response was recorded at sixteen response points at each subsystem. The measured CLF values were compared to each other from various aspects. Data were compared to the results obtained from SEA simulations by using the built-in analytical formulas. In general, good com-parison was observed, although the results appeared to be somewhat dependent on the frequency band. Finally, it was examined whether replacing the DLF values with data obtained for an uncoupled flat plate as well the CLF values with data from analytical formulas leads to acceptable accuracy of the re-sults.

Keywords: Statistical Energy Analysis, Damping Loss Factor, Coupling Loss Factor, Junction types, Vibration
Grants and funding:

The work is supported by the Hungarian Academy of Sciences and Audi Hungaria Zrt. through the funding provided to the MTA-SZE Lendület Vehicle Acoustics Research Group.

Received: February 21, 2021; Revised: May 4, 2021; Accepted: July 1, 2021; Prepublished online: July 4, 2021; Published: September 18, 2021  Show citation

ACS AIP APA ASA Harvard Chicago IEEE ISO690 MLA NLM Turabian Vancouver
Treszkai MF, Peiffer A, Feszty D. Power Injection Method-based evaluation of the effect of binding technique on the Coupling Loss Factors and Damping Loss Factors in Statistical Energy Anal-ysis simulations. Manufacturing Technology. 2021;21(4):544-558. doi: 10.21062/mft.2021.065.
Download citation

References

  1. LYON, R. H., DEJONG, R. G. (1995). Theory and Application of Statistical Energy Analysis, Butter-worth-Heinemann, Second Edition Go to original source...
  2. VA©INA M, HRU®ÍK L, BUREÈEK A. (2020) Study of Factors Affecting Vibration Damping Proper-ties of Multilayer Composite Structures, Manufacturing Technology, Vol. 20, No. 1, pp. 104-109. DOI: 10.21062/mft.2020.019. Go to original source...
  3. KOVÁÈIKOVÁ P, DUBEC A, VAVRO J. (2019) Comparison of Damping Effects of Two Types of Graphite Cast Iron, Manufacturing Technology, Vol. 19, No. 5, pp. 792-796. DOI: 10.21062/ujep/373.2019/a/1213-2489/MT/19/5/792 Go to original source...
  4. GU, J., SHENG, M. (2015.) Improved Energy Ratio Method to Estimate Coupling Loss Factors for Series Coupled Structure, Journal of Mechanical Engineering, Vol. 45, No. 1, pp. 37-40. Go to original source...
  5. BOUHAJ, M., ESTORFF, O., PEIFFER, A. (2017). An approach for the assessment of the statistical aspects of the SEA coupling loss factors and the vibrational energy transmission in complex aircraft structures: Experimental investigation and methods benchmark, Journal of Sound and Vibration, 403: pp. 152-172. DOI: http://dx.doi.org/10.1016/j.jsv.2017.05.028 Go to original source...
  6. JAMES P. P., FAHY, F. J. (1997). A technique for the assessment of strength of coupling between SEA subsystem: experiments with two coupled plates and two coupled rooms, Journal of Sound and Vibration, 203: pp. 401-407. Go to original source...
  7. BIES, D. A., HAMID, S. (1980). In situ determination of loss and coupling loss factors by the power injection method, Journal of Sound and Vibration, 70: pp. 187-204. Go to original source...
  8. SABLIK, M. J. (1982). Coupling Loss Factors at a beam L-joint revisited, Journal of Acoustic Society of Ameri-ca, Vol. 72, No. 4, pp. 1285-1288. Go to original source...
  9. MANDALE, B. M., BABU, P. B., SAWANT, S. M. (2016). Statistical energy analysis parameter estimation for different structural junctions of rectangular plates, Journal of Mechanical Engineering Science, Vol. 230, No. 15, pp. 2603-2610. DOI: 10.1177/0954406215615628 Go to original source...
  10. MANDALE, B. M., POPURI, B. (2019). Estimation of coupling loss factors for rectangular plates with different materials and junctions, Noise & Vibration Worldwide, 50(9-11), pp. 306-312. DOI: 10.1177/0957456519883264 Go to original source...
  11. LE BOT, et al. (2017). Statistical Energy Analysis, Assumptions and Validity, Medyna 2017: 2nd Euro-Mediterranean Conference on Structural Dynamics and Vibroacoutics, Sevilla, Spain, 25-27 Apr.
  12. PATIL, V. H., MANIK, D. N. (2019). Sensitivity analysis of a two-plate coupled system in the statistical energy analysis (SEA) framework, Springer, Structural and Multidisciplinary Optimization, 59: pp. 201-228. DOI: https://doi.org/10.1007/s00158-018-2061-9 Go to original source...
  13. PANUSZKA, R., WICIAK, J., IWANIEC, M. (2005). Experimental Assessment of Coupling Loss Fac-tors of Thin Rectangular Plates, Archives of Acoustics, Vol. 30, No. 4,
  14. pp. 533-551.
  15. [14] BOSMANS, MEES, P., VERMEIR, G. (1996). Structure-borne sound transmission between thin orthotropic plates: analytical solutions, Journal of Sound and Vibration, Vol. 191, No. 1, pp. 75-90. Go to original source...
  16. [15] CUSCHIERI, M., SUN, J. C. (1994). Use of Statistical Energy Analysis for Rotating Machinery: Determination of Dissipation and Coupling Loss Factors Using Energy Ratios, Journal of Sound and Vibration, Vol. 170, No. 2, pp. 181-190. Go to original source...
  17. [16] WESTER, E. C. N., MACE, B. R. (1996). Statistical Energy Analysis of Two Edge-Coupled Rectangular Plates: Ensemble Averages, Journal of Sound and Vibration, Vol. 193, No. 4, pp. 793-822. Go to original source...
  18. [17] WÖHLE, W., BECKMANN, Th., SCHRECKENBACH, H. (1981). Coupling Loss Factors for Statistical Energy Analysis of Sound Transmission at Rectangular Structural Slab Joints, Part I., Journal of Sound and Vibration, Vol. 77, No. 3, pp. 323-334. Go to original source...
  19. [18] WÖHLE, W., BECKMANN, Th., SCHRECKENBACH, H. (1981). Coupling Loss Factors for Statistical Energy Analysis of Sound Transmission at Rectangular Structural Slab Joints, Part II., Journal of Sound and Vibration, Vol. 77, No. 3, pp. 335-344. Go to original source...
  20. [19] DESMET, W., et al. (2012). "MID-FREQUENCY" - CAE Methodologies for Mid-Frequency Analysis in Vibra-tion and Acoustics, ISBN 978-94-6018-523-6
  21. [20] MECAS ESI Group, (2018). VA One Users' Guide
  22. [21] HENKEL. (2012). " Technical Data Sheet of Loctite® 454™" [Revised Nov. 2020] http://tds.henkel.com/tds5/Studio/ShowPDF/243%20NEW-EN?pid=454-2012%20NEW&format=MTR⊂format=REAC〈uage=EN&plant=WERCS
  23. [22] HENKEL. (2014). " Technical Data Sheet of Loctite® EA 3450™" [Revised Nov. 2020] http://tds.henkel.com/tds5/Studio/ShowPDF/243%20NEW-EN?pid=EA%203450&format=MTR⊂format=REAC〈uage=EN&plant=WERCS
  24. [23] LANGLEY R. S., HERON, K. H. (1990). Elastic wave transmission through plate/beam junctions, Jour-nal of Sound and Vibration, Vol. 143, No. 2, pp. 241-253. Go to original source...
  25. [24] LANGLEY R. S., SHORTER, P. J. (2003). The wave transmission coefficients and coupling loss factors of point connected structures, The Journal of the Acoustical Society of America, Vol. 113, No. 4, pp. 1947-1964. Go to original source...
  26. [25] FREDÖ, C. R. (1999). A Note on Conservative and Non-conservative Coupling, in F. J. Fahy, W. G. Price (eds), IUTAM Symposium on Statistical Energy Analysis, Solid Mechanics and Its Applications, vol 67. Springer, Dordrecht, pp. 95-106. ISBN: 978-90-481-5131-8 Go to original source...
  27. DOI: https://doi.org/10.1007/978-94-015-9173-7_9 Go to original source...
  28. [26] TRESZKAI, M. F., SIPOS, D., FESZTY, D. (2020). Damping Determination by Half-Power Bandwidth Method for a Slightly Damped Rectangular Steel Plate in the Mid-Frequency Range, Acta Technica Jau-rinensis, Vol. 13, No. 3, pp. 177-196. DOI: 10.14513/actatechjaur.v13.n3.545 Go to original source...

This is an open access article distributed under the terms of the Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.