Manufacturing Technology 2019, 19(4):655-659 | DOI: 10.21062/ujep/350.2019/a/1213-2489/MT/19/4/655

Prediction of Foaming Process in the Production of Aluminium Foams

Iva Nová¹, Jiří Sobotka¹, Karel Fraňa², Pavel Solfronk¹, David Koreček¹, Iva Nováková¹

¹ Technical University of Liberec, Faculty of Mechanical Engineering, Department Engineering Technology. Studentská 1402/2, Czech Republic

² Technical University of Liberec, Faculty of Mechanical Engineering, Department of Energy Facilities. Studentská 1402/2, Czech Republic

The paper deals with the physical-chemical effects of a blowing agent on production the cellular metal systems (in this case aluminium foams). Based on the isothermal concertation and pressure curves for the H-Ti system and by using the maximum gas volume obtained from equation of state, there was applied the blowing agent to 1 kg of AlSi12 aluminium alloy. Moreover, using relation to determine aluminium foam relative density (ρ REL) from alloy AlSi12, there was done prediction to determine density of 1 kg metal foam from AlSi12 alloy at different blowing agent contents from 0.1 up to 1.5 wt% of titanium hydride TiH 2. These isothermal calculations were compared with the density of aluminium foal from alloy AlSi12, which was produced by an industrial process. Basic mechanical properties were subsequently measured on the produced foam samples.

Keywords: Aluminium foam, aluminium alloy, foaming process, volume, foam density

Grants and funding:

The project “Hybrid materials for hierarchical structures”, re-search goal: Composite materials and structures, re-search program: Materials and structures on the metal basis, reg. no. CZ.02.1./0.0/0.0/16_019/0000843 pro-vided by the European Union and the Czech government.

Published: August 1, 2019  Show citation