Manufacturing Technology 2019, 19(6):923-929 | DOI: 10.21062/ujep/397.2019/a/1213-2489/MT/19/6/923

Research on Distribution Automation Based on Power Supply Reliability

Shuai Du
Nanjing University of Science and Technology Institute of Automation, Nanjing, Jiangsu 210094, China

The development of economy can not be separated from sufficient energy supply. With the progress of technology, the distribution network gradually expands the capacity and transportation, but also brings security risks. The distribution automation system can effectively manage the power grid faults. This paper briefly introduced the calculation model of the economic cost and the reliability rate of the distribution automation, and then the assembly scheme of the distribution terminal was optimized by using the improved binary particle swarm optimization (PSO) algorithm. Next, the simulation analysis of the distribution terminal distribution on a 10KV main feeder line in Xuanwu District of Nanjing city was carried out in MATLAB software. The results showed that the improved binary PSO algorithm could optimize the assembly scheme of remote metering and remote signalling and the assembly scheme of remote metering, remote signalling and remote control rapidly; the hybrid assembly scheme needed a little more time; the power supply reliability rate of the optimized three terminal assembly schemes was over 99%; the hybrid assembly scheme had higher power supply reliability rate and the lowest economic cost.

Keywords: Distribution Automation, Economic Cost, Power Supply Reliability, Particle Swarm Optimization

Published: December 1, 2019  Show citation

ACS AIP APA ASA Harvard Chicago IEEE ISO690 MLA NLM Turabian Vancouver
Du S. Research on Distribution Automation Based on Power Supply Reliability. Manufacturing Technology. 2019;19(6):923-929. doi: 10.21062/ujep/397.2019/a/1213-2489/MT/19/6/923.
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. GAN, G., WANG, Z., ZHOU, Y., LI, L., LI, X.Q. (2015). Reliability and Economy Based Closed-loop Operation Modes for Medium Voltage Distribution Networks. In: Automation of Electric Power Systems, Vol. 39, No. 16, pp. 144-150.
    2. LI, B., ZHU, J., LI, P.J., WEI, H. (2015). Island Partition of Distribution Network with Unreliable Distributed Generators. In: Automation of Electric Power Systems, Vol. 39, No. 8, pp. 59-65.
    3. SOBOTKA, J., SOLFRONK, P., KOLNEROVA, M., KORECEK, D. (2019). Input Data Acquisition Possibilities for Numerical Simulation of Drawing Process by means of the Contact-less Optical System and Thermo-camera. In: Manufacturing Technology, Vol. 1, pp. 144-149. Go to original source...
    4. ONEN, A., JUNG, J., DILEK, M., CHENG, D., BROADWATER, R.P., SCIRBONA, C., COCKS, G., HAMILTON, S., WANG, X.Y. (2016). Model-centric Distribution Automation: Capacity, Reliability, and Efficiency. In: Electric Power Components and Systems, Vol. 44, No. 5, pp. 1-11. Go to original source...
    5. JAMALI, S., BAHMANYAR, A. (2016). A new fault location method for distribution networks using sparse measurements. In: International Journal of Electrical Power & Energy Systems, Vol. 81, pp. 459-468. Go to original source...
    6. LIU, H., LI, J., ZHANG, J., SUN, H., LIU, W., QU, G.Q. (2017). Power Supply Capability Evaluation of Medium Voltage Distribution System Considering Reliability. In: Automation of Electric Power Systems, Vol. 41, No. 12, pp. 154-160.
    7. GUO, J., YAO, J., LIU, M., HU, J., SONG, T. (2015). A Routing Algorithm to Prolong Network Lifetime for City Distribution Network. In: Automation of Electric Power Systems, Vol. 39, No. 12, pp. 113-120. Go to original source...
    8. HEIDARI, A., AGELIDIS, V.G., KIA, M., POU, J., AGHAEI, J., SHAFIE-KHAH, M., CATALAO, J.P.S. (2017). Reliability Optimization of Automated Distribution Networks With Probability Customer Interruption Cost Model in the Presence of DG Units. In: IEEE Transactions on Smart Grid, Vol. 8, No. 1, pp. 305-315. Go to original source...
    9. CHEN, D., WU, Z. (2017). Dynamic planning of distribution automation terminal units placement optimization. In: Power System Protection & Control, Vol. 45, No. 12, pp. 1-8.
    10. SUN, X., ZHOU, Q.J., WANG, B., FU, L.M. (2015). Analysis and Suggestions for Power Supply Reliability Assessment Index of Distribution Network. In: Applied Mechanics and Materials, Vol. 733, pp. 726-729. Go to original source...
    11. ZHANG, E.Z., CHEN, Q.W. (2015). Multi-objective particle swarm optimization for uncertain reliability optimization problems. In: Control & Decision, Vol. 4, No. 2, pp. 3915 - 3920.
    12. FENG, Z., SI, J., WANG, J. (2016). Research on optimal schedule strategy for active distribution network using particle swarm optimization combined with bacterial foraging algorithm. In: International Journal of Electrical Power & Energy Systems, Vol. 78, pp. 637-646. Go to original source...
    13. WU, Y.M., XU, Y.X., LUO, L.F., ZHANG, H., ZHAO, X.D. (2018). Research on evolution balancing for product family assembly line in big data environment. In: Manufacturing Technology, Vol. 2, pp. 337-342. Go to original source...
    14. TIAN, D. (2017). Particle Swarm Optimization with Chaos-based Initialization for Numerical Optimization. In: Intelligent Automation & Soft Computing, Vol. 24, No. 1, pp. 1-12. Go to original source...
    15. QIN, Q., CHENG, S., ZHANG, Q., WEI, Y., SHI, Y. (2015). Multiple strategies based orthogonal design particle swarm optimizer for numerical optimization. In: Computers & Operations Research, Vol. 60, No. C, pp. 91-110. Go to original source...
    16. SUJOVÁ, E., STĜIHAVKOVÁ, E., ÈIERNA, H. (2018). An analysis of the assembly line modernization by using simulation software. In: Manufacturing Technology, Vol. 5, pp. 839-845. Go to original source...

    This is an open access article distributed under the terms of the Attribution-NonCommercial 4.0 International License (CC BY-NC 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content